.....In order to have ALCOFLEX installed in your car, no power cables in the original electrical system have to be chopped.

.....A cable tie is provided in your product pack. This is to be used in fitting your ALCOFLEX inside the engine compartment (hood), making any holes in the sheet metal totally unnecessary.

.....The device is best accomodated between the original connectors leading to the injection nozzles and the electronic central control unit (injection module), by means of connectors designed to best fit the original pattern and design. We consider it indispensable to preserve such original features in all compatible models.

.....After the installation is complete, the technician must then select the most suitable timing parameter adjustment to your engine type. In the front inferior position there is an adjustment control ranging from 20% to 50% of the timing to be increased. Such adjustment must be made with an attached SCANNER in order to ensure the proper functioning of the LAMBDA system and therefore your vehicle´s optimal performance.

ONCE INJECTION TIMING PARAMETERS ARE ADJUSTED, NO FURTHER CHANGES ARE NECESSARY. THIS PROCEDURE IS FOLLOWED ONLY DURING INSTALLING.

.....As soon as ALCOFLEX is installed, you may as well fully enjoy its outstanding benefits: you are now a part of those privileged few to get opportunity to use cutting edge fuel technology to your advantage, at an attractively low cost.

BEFORE INSTALLING ALCOFLEX, READ OUR RECOMMENDATIONS SECTION.